Electrolux OHV User Manual
Page 42
42
43
7.46 Disassemble Drive Plate / Drive
Pulley Assembly (Shaft Lubrication
INSTRUCTION )
7.47 Replace Wheel Drive Axle / Gear
1) Remove Frame Bottom Pan. Section 7.42.
2) Remove covers and disassemble power
steering on both sides if so equipped.
4) Inspect parts for wear and replace if
necessary.
5) Lubricate all sides of Hex Shaft with metallic
anti-seize compound.
6) Reverse the order to reassemble.
NOTE: Lubrication of the Hex Shaft with
metallic antiseize compound is recommended
every 120 hours of operation.
If this assembly
is removed, we recommend the hex shaft is
lubricated with anti-seize compound.
1) Unhook Spring from Clutch Rod (key 11)
2) Remove Hairpin Retainer (key 22) from the
Shift Plate Lever.
3) Remove Pivot Pin and separate Drive Plate
(key 26) from hex shaft.
4) Slide the axle out the right side and replace
damaged parts.
5) Reverse process to reassemble. Make
sure the square key, roll pin, and thrust
washer is located between gear and
bearing
3) Remove the screws on the right side that
secure axle bushing to the frame.
SPRING
CLUTCH ROD
PIVOT PIN
HAIRPIN RETAINER
SHIFT PLATE LEVER
LUBRICATE HEX SHAFT
AXLE
BEARING
SCREWS
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com