Electrolux OHV - Manual (Page 31)

30 31
Section 7.16: Replace Chute Rotator Cable
1) Remove control panel (see section 7.11
above, for Control Panel removal instructions)
Section 7.17: Replace Chute Deflector Control
1) Remove control panel (see section 7.11).
CABLE ASSEMBLY
ROTATOR HEAD
3) Remove spring from deflector, if applicable.
4) Remove 9/16
" nut holding control rotator
head to tubular support, and remove cable
assembly from the chute. The chute will not
be retained at the top, DO NOT drop chute.
5) Cut all cable ties noting locations, and
paying attention to the routing of cable
particularly at the lower handle.
6) Reverse process to install new cable. Install
new plastic ties to hold cables.
2) Remove both 5/16 " screws holding rotator
control to handle assembly.
4) Remove both 5/16" screws that secure cable
assembly to the handle assembly.
5) Cut the cable ties that secure the cable to
the snowthrower, paying attention to the routing
of the cable and the location of ties.
6) Reverse process to install the cable and new
plastic ties.
2) Remove the nut and washer that secure the
cable eyelet to the deflector.
3) Remove the nut, washer and bracket that
secure cable to the chute.
SPRING
NUT AND
WASHER
DEFLECTOR
CABLE
SCREWS
CHUTE ROTATOR
CONTROL LEVER
DEFLECTOR
CABLE
ASSEMBLY
SCREWS
DEFLECTOR
CONTROL
LEVER
9/16" NUT
SPRING
CABLE ASSEMBLY
ROTATOR HEAD
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com