Electrolux OHV - Manual (Page 12)

12 13
CONSUMER OPERATION
LH and RH turn triggers - used to steer the snow thrower.
Drive speed control lever - used to select forward or reverse
motion and speed of snow thrower.
Traction drive control lever - used to engage power-propelled
forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the direction
the snow is thrown.
Deflector remote control lever - used to change the distance
the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground. Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to start and
run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the en-
gine.
Primer - pumps additional fuel from the carburetor to the cylinder
for use when starting a cold engine.
Choke Control - used for starting a cold engine.
Throttle/engine control - used to select either FAST or SLOW
engine speed and to STOP the engine.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
TRACTION
DRIVE CON-
TROL LEVER
DISCHARGE CHUTE CONTROL LEVER
RECOIL (AUXIL-
IARY) STARTER
HANDLE
THROTTLE /
ENGINE CON-
TROL
DEFLECTOR REMOTE CON-
TROL LEVER
DRIVE SPEED CON-
TROL LEVER
AUGER CON-
TROL LEVER
MUFFLER
TOOLBOX
HANDLE
KNOB
LH TURN
TRIGGER
SKID PLATE
CHUTE DE-
FLECTOR
DISCHARGE
CHUTE
AUGER
GASOLINE
FILLER
CAP
ENGINE OIL CAP
WITH DIPSTICK
SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
ELECTRIC
START BUT-
TON
PRIMER
FUEL SHUT-OFF VALVE
NOTE: ITEMS
ABOVE ARE SHOWN
IN THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
LIGHT
OIL DRAIN
PLUG
POWER
CORD
PLUG
FIG. 12
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com