Livarno COLOUR-CHANGE CEILING LIGHT - Manual (Page 31)

31 GB
Safety Introduction
Safety
Safety notices
Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to comply
with the safety instructions!
DANGER TO LIFE AND
ACCIDENT HAZARD FOR
TODDLERS AND SMALL CHIL-
DREN! Never leave children unattended with
the packaging material. The packaging mate-
rial represents a danger of suffocation. Children
frequently underestimate the dangers. Please
keep children away from the product at all times.
Avoid the risk of fatal injury
from electric shock
Protection class II / . This light is specially in-
sulated and must not be connected to an earth
conductor.
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, per-
forms the electrical installation.
We assume no liability for material damage or
personal injury due to improper handling or
failure to comply with the safety instructions!
Never use the light if any defects have been
identified.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Before assembly, ensure that the available
mains voltage corresponds to the operating
voltage necessary for the light (230–240 V∼).
Ensure that no cables are damaged when in-
stalling.
Do not install the lamp on damp if conductive
surfaces.
Prevent fire and
injury hazards
0.3 m
Install the light so that it is at least
0.3 m from any illuminated materials.
Fire can result from the development
of too much heat.
To prevent burns, ensure that the light is switched
off and has cooled down before touching it.
Lamps develop a lot of heat in the area of the
lamp head.
Attention! Do not touch bulb components or
bulbs during operation as they can reach tem-
peratures > 90 °C.
Allow the light to cool down completely before
replacing a defective bulb.
Replace defective bulbs with new ones immedi-
ately. Use only those bulbs as stated in the
chapter on “Technical Data”. Before changing
bulbs, always first remove the fuse or switch off
the circuit breaker.
The LED light bulbs are permanently fitted and
are not replaceable.
Do not look directly into the light source (light
bulb, LED etc.).
The permanently fitted LED light bulbs are not
suitable for dimmer or electronic switches.
Safe working
Only uses 12 V∼ halogen light bulbs with a
G4 socket and a maximum output of 14 Watt.
Do not touch the halogen lamps with bare hands.
If this accidentally occurs, the light bulb must
be wiped with alcohol and a lint-free cloth.
Only use halogen light bulbs with
cover glass or low-pressure
technology.
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and proceed with caution