Livarno COLOUR-CHANGE CEILING LIGHT - Manual (Page 33)

33 GB
Start-up Safety / Preparation / Installation
Start-up
Inserting / replacing
batteries (remote control)
Open the battery compartment at the back of
the remote control 16 .
Remove the spent battery, if necessary.
Insert a new battery into the battery compart-
ment. Only use type 23 A, 12 V batteries.
Note: Be sure to correctly insert the batteries
(polarity). This is indicated on the battery cover.
Close the battery compartment of the remote
control 16 .
Installing the wall bracket
(remote control)
Hold the wall bracket 18 in the desired location
on the wall and mark the drill holes.
Now drill the mounting holes.
Insert the rawlplugs
19 into the drill holes.
Secure the wall bracket 18 using the included
screws 17 .
Tighten the screws to secure the wall bracket 18 .
Do not overtighten the screws 17 .
Place the remote control 16 into the wall
bracket 18 .
Switching the luminaire on / off
You have the possibility of operating the luminaire
from an ordinary wall switch or switching it on and
off using the supplied remote control unit.
Switching the luminaire on / off using the
remote control unit:
– The wall switch is in the basic position (OFF).
Activate the wall switch (ON).
Press the ON button on the remote control
16 to
switch the light on (halogen light bulb and LED).
Push the OFF button on the remote control 16 to
switch the light completely off.
Switching the light on / off with the wall
switch
The wall switch is in the basic position (OFF).
Activate the wall switch (ON). The halogen
light bulbs are on.
Activate the wall switch within approx. 1 second
by repeatedly pushing off and on. This will
switch through the various switch positions
(halogen light bulbs and LED).
The light can be switched off with the wall switch
or the remote control 16 .
Remote control functions
ON / OFF Halogen light bulb and LED on or off
End colour change / colour selection
Colour
Changing slow colour change LED:
Press 1 x = rotate left
Press 2 x = rotate right
rapid colour change LED:
Press 3 x = rotate left
Press 4 x = rotate right
Press 5 x = flowing colour
change LED
Lamp Halogen light bulb on or off
Colour
Selection Press 1 x:
blue LED
Press 2 x: green LED
Press 3 x: red LED
Press 4 x: green / blue LED
Press 5 x: green / red LED
Press 6 x: red / blue LED
Press 7 x: green / red / blue LED
Troubleshooting:
If the remote control
16 does not respond after
switching the light on, first press the wall switch to
switch the light off. Then wait approx. 15–20 sec-
onds and activate the wall switch again.
If after switching on the luminaire again via the
remote control unit
16 the luminaire still does not
respond, check the batteries in the remote control
unit
16 .