Epson 200 - Manual (Page 36)

3.2.2 C199 MAIN Control Board and ASF Sensor Removal
1. Remove the upper case (see Section 3.2.1).
2. Remove 4CBB (M3
×
6) screws attaching the shield frame to the C160 MAIN Board.
3. Remove 7 connectors (CN1, CN8, CN7, CN4, CN3, CN5, CN6) on the main board. (Push CN6 down to
release cable on main board.) Then remove the C199 Main Control Board.
4. Remove a CBB (M3x6) screw fixing a ASF Sensor holder to printer mechanism.
When you replace the C199 MAIN Board, reset the EEPROM and perform the required
adjustments. (See Chapter 4.)
CBB(M3x6)
C160 PSB/PSE Board
ASF Sensor Holder
Figure 3-3. ASF Sensor Removal
CB B(M 3x 6)
CBB(M3x6)
CB B(M 3x 6)
CB B(M3 x6)
Shield Plate
C N 1
C N 8
C N 7
C N 4
C N 3
C N 5
C N 6
C1 99 Main B oa rd
C N 9
Figure 3-2. C199 Main Board Removal
CAUTION
EPSON Stylus Color 200 / EPSON Stylus 200 Disassembly and Assembly
Rev. A 3-3