Epson 500 - Manual (Page 19)

Displaying and Adjusting the Image
19
Inverting and Mirroring the Image
If the image is displayed upside-down or backward, select the correct Projection option:
1. Press the Menu button on the remote control.
2. Use the menu navigation buttons to open the Setting
menu, then open the Screen menu, and then select
Projection .
3. Choose from these options:
■ Front if the projector is located in front of the
screen (for example, on a table).
■ Front/Ceiling if the projector is located in front
of the screen and mounted overhead.
■ Rear if the projector is located behind the screen.
■ Rear/Ceiling if the projector is located behind
the screen and mounted overhead.
Selecting the Input Signal Setting
If you’re using the projector’s Input A or Input B port, select the correct setting for the type of
equipment you’ve connected to it:
1. Press the Menu button on the remote control.
2. Use the menu navigation buttons to open the Setting menu, then open the Input Signal
menu, and then select Input A or Input B (depending on the port to which you’ve
connected the equipment).
3. Choose from these options:
■ YCbCr if your video player outputs an NTSC signal.
■ YPbPr if your video player outputs an HDTV signal.
■ RGB-Video if your video player outputs an RGB video signal.
■ RGB if the image is coming from a computer.
Note: If you’re unsure which setting to use, check the label next to the port on your video
equipment.
Menu
button
Menu
navigation
buttons