RISCO Group Wireless WatchOUT PIR 312PR - Manual (Page 16)

16 WatchOUT PIR Installation Manual
4. Press / to confirm.
5. Repeat the process for the other BUS detectors.
Assigning the WatchOUT 312PIR to a Zone
1. From the main installer menu enter Zones: One by One option (Quick key [2][1] )
2. Select the zone number that you want to assign the BUS detector .
Note:
If you defined a BUS Zone Expander select a zone number from the virtual zones (defined
by the BUS zone expander).
3. Define Partitions, Groups, Zone Type and Zone Sound.
4. In the Termination category select [5] Bus Zone followed by / . The
following display appears:
Z:001 LINK TO:
ID:01 TYPE:OPR12 Z:001 LINK TO:
ID:01 TYPE:OPR12
5. Select the BUS zone number to assign to the programmed zone. The type field will be
updated automatically when selecting the BUS zone.
6. Press / . The loop response category is not applicable to a BUS zone and
the following display appears:
Z:001 RESPONSE:
N/A-BUS ZONE Z:001 RESPONSE:
N/A-BUS ZONE
7. Press / , assign label and press /
Configuring the WatchOUT 312PIR Parameters
1. To access the WatchOUT settings option press [2][0][3] from the main installer menu.
The following display appears:
B-ZONE PRMS:
ZONE#=001 (M:ZZ) B-ZONE PRMS:
ZONE#=001 (M:ZZ)
2. Select the zone that the BUS zone was assigned to and press / . You can
now program the WatchOUT parameters as follows:
Zones Miscellaneous: BUS Zone
Quick Keys Parameter Default
[2][0][3][zzz]
[1]
LEDS 3 LEDS
Defines the LEDS operation mode
[2][0][3][zzz]
[1][1]
Off
Disables the LEDS operation
[2][0][3][zzz]
[1][2]
Red Only
Only the Red led will operate. This option is highly recommended to avoid
the possibility that the intruder will “Learn” the detector behavior.
[2][0][3][zzz]
[1][3]
3 LEDS
All 3 LEDs will operate
[2][0][3][zzz]
[2]
PIR Sensitivity Normal
Defines the PIR sensitivity of the detector
[2][0][3][zz]
[2][1]..[4]
Sensitivity Options