RIGOL DS6000 Series - Manual (Page 178)

RIGOL 7 Protocol Decoding
DS6000 User’s Guide 7-20
7. Display-related Setting
Press Format to set the display format of the bus to Hex, Decimal, Binary or
ASCII.
Press Offset and use to adjust the vertical display position of the bus.
Press BusStatus to enable or disable bus display.
8. Decoding Table
The decoding table lists the decoded data, the corresponding line number, time
and error information in table format. It can be used to observe relatively longer
decoded data to solve the problem that some data could not be seen clearly on
the screen.
Press Event Table  Event Table to select “ON” (note that this operation is
only available when BusStatus is set to “ON”) to enter the decoding table
interface as shown in the figure below. If a USB storage device is currently
connected to the instrument, users can export the data table to the external USB
storage device in CSV format.