Rose Electronics ServeView Pro - Manual (Page 13)

SERVEVIEW PRO INSTALLATION AND OPERATIONS MANUAL 9
Keyboard command usage
When using keyboard commands to enter information to the ServeView
Pro, please observe the following guidelines to avoid entering incorrect
values or no values.
1. All commands start with a press and release of the left control key.
2. Commands following the press and release of the left control key must
be entered within 2 seconds or the command is aborted and the
additional keystrokes will be sent to the selected computer and not the
ServeView Pro.
3. Use only the numeric keys above the keyboard and not the numeric
keypad.
4. Letter commands such as <Ctrl> M are not case sensitive and are only
shown in uppercase for clarity. Do not use the shift key to enter letter
commands.
5. To connect to the previous or next computer, the keyboard command is
<Ctrl> - or <Ctrl> +. The plus and minus keys on the keypad will
connect to the next or previous computer. The - and + keys on the
keyboard, next to the backspace key vary from country to country as to
their usage. These keys can still be used to connect to the next or
previous computer.