Encore electronic ENHWI-G2 - Manual (Page 33)

PPPoE Mode
User Name, password
and service name Fill in the User Name, password and service name that
provided by your ISP.
Connection Type “Continuous” is for Always keep connection
“Connect on demand” is for bill by connection time.
You can set up the Idle time for the value specifies the
number of time that elapses before the system
automatically disconnects the PPPoE session.
“Manual” To connect to ISP, click “Connect” manually
from the WEB user interface. The WAN connection will
not disconnected due to the idle timeout. If the WAN
line breaks down and latter links again, the router will
not auto-connect to the ISP.
Idle Time:
The value specifies the number of idle time
that elapses before the system automatically
disconnects the PPPoE session.
MTU Size To Enable the Maximum Transmission Unit of Router
setup. Any packet over this number will be chopped up
into suitable size before sending. Larger number will
enhance the transmission performance.
Enter your MTU number in the text-box to set the
limitation.
Attain DNS automatically: If your DNS provide by ISP is dynamic, choose
“Attain DNS automatically
Set DNS Manually To specify the DNS, and enter the DNS provided by
your ISP in DNS 1 2 3.
28