Encore electronic ENHWI-G2 - Manual (Page 37)

IP filtering
ENCORE Router could filter the outgoing packets for security or
management consideration. You can set up the filter against the IP
addresses to block specific internal users from accessing the
Internet.
Configuration
1. Click the check box of “Enable IP Filtering” to enable
the function.
2. Enter the specific Local IP address (EX 10.10.3.9),
Protocol (UDP/TCP), and comment (EX. Peter)
STEPS
3. To Delete the IP address on the list, Click the check
box in the select item and click the “Delete Selected”.
If you want to delete all entries on the list, click
“Delete All” to remove all of them.
32
Click <Apply Change> at the bottom of the screen to save the above configurations. You
can now configure other advance sections or start using the router.