Amprobe SOLAR-500 Solar-Analyzer User Manual
Page 17
11
3. Press
button to start MANUAL SCAN. After the scanning is
finished, the result will come out like below.
If users are interested in a specific point of test current, users can enter
the current value for a Single Test Point. Press TEST (
) to test the
characteristics at the current.
1. Press
button to turn on the Analyzer. Properly connect the pair of
Kelvin clips to the solar panel and the Analyzer. The red Kelvin clip is for
positive pole and the black Kelvin clip for negative pole.
2. Press
button to enter the SETUP menu: (Type in the testing current)
Single Test Point: 609mA
After setting up the current range, press
button again to exit the
SETUP menu.
3. Press
button to start Testing a Single Test. After the testing is
finished, theresult will come out like below. The result (P, V, I) is shown in
reverse video as below.