Clear: "clr" key, Pla 02 – Amprobe Multitest-1000 Continuity-Tester User Manual
Page 45
5.3.
CLEAR: "CLR" KEY
If you want to cancel the stored tests results proceed as follows:
1. Press
the
RCL/ESC key. The instrument displays a screen like the
following:
MEM
3
Pla
02
2.
Use the & keys to select the number of the memory location.
ATTENTION: The instrument will cancel all the results stored from the memory location
selected to the last.
3. Press
the
DISP key to display the test result related to the memory
location selected.
4.
Press CLR once. The blinking symbol "
clr"
is displayed. Now you face
two possibilities:
MEM
C
i
02
08
Number of the memory location in which the
measurement result was stored.
Value of the parameter PLA related to the
saved measurement.
DISP
Last location with data stored.
The instrument cancels the memory cells from
n.2 to n.8, where n.2 is the one selected by
the operator while n.8 is the last test saved in
the instrument.
CLR
RCL
ESC
CLR
Press CLR again if the tests selected are to be cancelled
starting from the one selected down to the last one saved.
RCL
ESC