Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 29)

Avago Technologies
- 29 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU06 Unit
2.3.2.2 Installing the LSIiBBU06 Unit Directly on the RAID Controller
Follow these steps to install the LSIiBBU06 unit on the RAID controller.
1. Ground yourself, and remove the LSIiBBU06 daughter card from the package.
2. Insert the battery pack harness connector at the end of the 5-pin cable into the 5-pin J4 connector on the back
side of the LSIiBBU06 unit.
3. Place the LSIiBBU08 unit top-side up on a flat, clean, static-free surface.
4. Place the RAID controller front-side up on a flat, clean, static-free surface.
5. Hold the LSIiBBU06 daughtercard so that the battery side is facing upward and the J5 connector lines up with the
J10 BBU connector on the RAID controller, as shown in the following figure.
Figure 14 Installing the LSIiBBU06 Daughtercard on the MegaRAID SAS 8708EM2 RAID Controller
6. Carefully press the LSIiBBU06 unit onto the RAID controller so that the two connectors are firmly joined.
7. Use the Phillips-head screws and standoffs that are provided to secure the LSIiBBU06 daughter card to the RAID
controller using the three screw holes
The standoffs are threaded at both ends, and a screw goes into each end.
NOTE Center the screwdriver carefully to avoid stripping the screw heads.
Do not overtighten the screws.
85024-01
J10