Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 95)

Avago Technologies
- 95 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Connecting a CVFM02 Module on a RAID Controller to a CVPM02 Module Mounted on a
Remote Mount Board
2.9.6 Installing the Remote Mount Board in the System
Follow these steps to install the remote mount board in the computer.
1. With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCIe slot on the motherboard, as shown in the following figure.
NOTE This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
Some PCIe slots, however, support only PCIe graphics cards; if a
remote mount board is installed in one of these slots, the remote
mount board will not function. Refer to the guide for your
motherboard for information about the PCIe slot.
3. Press down gently, but firmly, to seat the board correctly in the slot.
4. Secure the remote mount board to the computer chassis with the bracket screw.
Figure 64 Installing the Remote Mount Board
Bracket
Screw
Press
Here
Press
Here
3_00895-00