PLANET WSG-500 - Manual (Page 124)

120
3) Using DHCP: If you want to use DHCP,
click on the IP Address tab and choose
“Obtain an IP address automatically”,
and then click OK. This is also the default
setting of Windows. Then, reboot the PC to
make sure an IP address is obtained from
WSG-500.
4) Using Specific IP Address: If you want to use a specific IP address, acquire the following
information from the network administrator: the IP Address, Subnet Mask and DNS Server
address provided by your ISP and the Gateway address of WSG-500.
Caution:
If your PC has been set up completely, please inform the network administrator before proceeding to
the following steps.
4.1) Click on the IP Address tab and choose
“Specify an IP address”. Enter the IP
Address, Subnet Mask and then click
OK.