Panasonic Lumix GH5 - Manual (Page 113)

113
Others
(ENG) DVQX1052
• This is characteristic of MOS sensors which serve as the camera’s pickup sensors.
This is not a malfunction.
• When using the electronic shutter, lowering the shutter speed may reduce the effect of the
horizontal stripes.
• If noticeable flicker or striping is seen under lighting such as a fluorescent or LED lighting fixture
when recording motion pictures, you can reduce the flicker or striping by setting up [Flkr
Decrease] and fixing the shutter speed. It is possible to select a shutter speed from [1/50],
[1/60], [1/100], or [1/120]. You can set the shutter speed manually in the Creative Video Mode.
(P23)
• When recording under fluorescent or LED lighting fixture, etc., increasing the shutter speed
may introduce slight changes to brightness and color. These are a result of the characteristics
of the light source and do not indicate a malfunction.
• When recording subjects in extremely bright locations or recording under fluorescent lighting,
LED lighting fixture, mercury lamp, sodium lighting, etc., the colors and screen brightness may
change or horizontal striping may appear on the screen.
• If you continue to use the same card after changing [System Frequency] (P83), motion pictures
may not be recorded. To record with the same card, reset [System Frequency] to the original
setting. To record motion pictures with the current setting, try the following:
– Perform formatting (P16) on this unit after saving necessary data on a PC, etc.
– Insert a different card.
• You may not be able to record for a short while after turning this unit on when using a large
capacity card.
• When the ambient temperature is high or motion picture is recorded continuously, the camera
may display [ ] and stop the recording to protect itself. Wait until the camera cools down.
• This phenomenon occurs when the camera is trying to record with highly accurate focus at a
reduced Auto Focus speed, and is not a malfunction.
• When the electronic shutter is used, the flash is not activated.
• When [Silent Mode] is set to [ON], the flash is not activated.
Striping or flicker may appear under lighting such as fluorescent lighting and
LED lighting fixture.
The brightness or the hue of the recorded picture is different from the actual
scene.
Recording motion pictures is not possible.
Motion picture recording stops in the middle.
Sometimes it is difficult to focus with Auto Focus when recording 4K motion
pictures.
The flash is not activated.
DC-GH5LBodyP-DVQX1052_eng.book 113 ページ ２０１７年２月２日 木曜日 午後３時２１分