Panasonic Lumix GH5 User Manual

Page 114

Advertising
background image

Others

114

DVQX1052 (ENG)

• When [Sleep Mode], [Sleep Mode(Wi-Fi)], or [Power Save LVF Shooting] (P82) is activated, the

external flash may not enter sleep mode automatically. When the camera is turned off, the
external flash may not turn off automatically.
> In such cases, turn off the external flash manually.

• Is the card inserted?
• Is this a folder or picture which was processed in the PC?

If it is, it cannot be played back by this unit.
> It is recommended to use the software “PHOTOfunSTUDIO” (P104) to write pictures from

PC to card.

• Has [Playback Mode] been set for playback?

> Change to [Normal Play].

• Motion pictures recorded with a different [System Frequency] setting cannot be played back. (P83)

> Return the [System Frequency] setting to the one you used during the recording.

General tips for using a Wi-Fi connection

• Use within the communication range of the device to be connected.
• Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency

operated nearby?
> Radio waves may get interrupted when used simultaneously. Use them sufficiently away

from the device.

• When the battery indicator is flashing red, the connection with other equipment may not start or

the connection may be disrupted.
(A message such as [Communication error] is displayed.)

• If you place the camera on a metal table or shelf, the radio waves may be adversely affected. In

such cases, you may not be able to establish a connection. Move the camera away from the
metal surface.

About a wireless access point

• Check if the wireless access point to connect is in operating state.
• Check the radio wave condition of the wireless access point.

> Move this unit closer to the wireless access point.

> Change the location and orientation of the wireless access point.

• It may not display even if the radio waves exist depending on the setting of the wireless access point.

> Turn off and on the wireless access point.

> Check the settings of the wireless access point.

> When the network SSID of the wireless access point is set not to broadcast, the wireless

access point may not be detected. Enter the network SSID to start the connection or enable
the SSID broadcast of the wireless access point.

Even when the camera is put in sleep mode, the external flash does not enter
sleep mode.
Even when the camera is turned off, the external flash does not turn off.

The picture is not played back.
There are no recorded pictures.

A Wi-Fi connection cannot be established.
Radio waves get disconnected.
Wireless access point is not displayed.

DC-GH5LBodyP-DVQX1052_eng.book 114 ページ 2017年2月2日 木曜日 午後3時21分

Advertising
This manual is related to the following products: