Xiaomi Mi Vacuum Cleaner G10 - Manual (Page 10)

16 17
Care & Maintenance
5. Rinse the pre-filter, cyclone assembly, and dust compartment
with water until they are clean, then set each component aside to
thoroughly dry for at least 24 hours. Wipe the contact points of the vacuum cleaner with a soft dry
cloth if they are dirty.
1. Insert the cyclone assembly vertically into the dust
compartment, and make sure that the handle of the cyclone
assembly line up with the slot on the left side of the dust
compartment. Turn the handle clockwise until it locks, then flip
the handle down.
3. Slightly tilt the dust compartment so its slot aligns with the clip
on the vacuum cleaner. Then gently push the dust compartment
until it clicks into place.
2. Place the pre-filter with its front side facing up into the cyclone
assembly.
Installing the Dust Compartment, Pre-filter, and
Cyclone Assembly
Do not use detergents, polishes, or air fresheners to clean the
dust compartment.
Do not clean the dust compartment, pre-filter, or cyclone
assembly in a dishwasher or washing machine, nor attempt to
dry any component in a tumble dryer, oven, microwave, or near
an open fire.
Notes:
Notes:
The dust compartment should be rinsed out at least once a
month.
The pre-filter and cyclone assembly should be cleaned once
every 3 to 4 months.
1
2
Insert until it clicks
into place
Pre-filter Cyclone Assembly Dust Compartment
2
1 Pre-filter