Sony HDVF-EL30 0.7" FHD OLED Viewfinder with 3.5" Display for 4K/HD Cameras - Manual (Page 8)

8
Location and Function of Parts
Camera
SRG-XP1
Front
 Tally lamp
Lights up in red when a tally command is
received or the camera is selected by an
optional remote controller (depending on
the setting mode). The brightness can be
selected from [HIGH], [LOW], or [OFF] (the
tally lamp does not light up) in [TALLY LEVEL]
in the SYSTEM menu.
 Remote commander sensor
This is the sensor for the supplied remote
commander.
 Lens
The SRG-XP1 does not support optical zoom.
When [ZOOM MODE] in the ZOOM menu is
set to [PIXEL ZOOM], up to 2x zoom at 1080p
resolution, and up to 3x zoom at 720p
resolution is supported.
Used together with pixel zoom and digital
zoom, it achieves the equivalent of up to 6x
telephoto performance.
Note
Do not touch the part around the lens when
energized.
 Focus ring
Turn by hand to adjust the focus.
Note
Do not touch the part around the lens when
energized.
 Ceiling mount
Use the screw holes when attaching to a
ceiling or other high location.
For details, see “Installing the camera in a
high location” (page 16).
Back
 POWER lamp
Lights in green when the camera is
connected to an outlet using the supplied AC
adapter and power cord, or when power is
being supplied by connecting the camera
and PoE power supply device with a LAN
cable.
 12 V

(DC power input) terminal
Connect the AC adapter (supplied).
Note
Do not use any AC adapter other than the
supplied AC adapter. Otherwise, a fire or
malfunction may occur.
 LAN (network) terminal (RJ-45)
Network communication and PoE power
supply are provided using the network cable
(category 5e or higher, shielded twist pair).
For more information on the connection,
refer to the instruction manual of the PoE
power supply device.
The LED on the left lights up in orange when
the network is connected by 1000BASE-TX,
or in green when connected by 100BASE-TX.
It is turned off when the network is
connected by 10BASE-T or the network is
disconnected.
The LED on the right flashes during data
transfer.
Factory settings for network
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.254
Name: CAM1
User name: admin
Password: Admin_1234