Sony ECM-X7BMP Electret Condenser Lavalier Microphone for UWP Transmitters - Manual (Page 62)

Adjustment Using the Menus
62
[Protocol Setting]
Sets the required items for communications such as the
port number.
For the setting value, consult the network administrator.
[Parallel Remote]
Sets the parallel remote function.
Submenu Setting
[IP Address] Sets the IP address. (Default value:
[192.168.000.001])
Note
When the NETWORK switch is set to
PEER TO PEER, the IP address is set to
“192.168.0.1” regardless of the display.
When the NETWORK switch is set to
LAN, the IP address is set to the
displayed one.
[Subnet Mask] Sets the subnet mask. (Default value:
[255.255.255.000])
Note
When the NETWORK switch is set to
PEER TO PEER, the subnet mask is set
to “255.255.255.000” regardless of the
display.
When the NETWORK switch is set to
LAN, the subnet mask is set to the
displayed one.
[Default Gateway] Sets whether or not to set the default
gateway ([Off] or [On]).
[Address] Sets the address of the default gateway.
(Default value: [---.---.---.---] (no
setting))
[Cancel] Cancels the changed or confirmed
setting.
[Confirm] Saves the changed or confirmed setting.
Submenu Setting
[SDCP/SDAP
Community] Sets the SDCP/SDAP community
name.
When the item is selected, you can enter
the community name (four characters).
 [SONY]: SONY is entered as a
community name.
 [New Name]: Enter a new name.
[SDCP Port No] Sets the SDCP port number.
Set from 53434 to 53534. (Default value:
[53484])
[SDAP Port No] Sets the SDAP port number.
Set from 53812 to 53912. (Default value:
[53862])
[SDAP Broadcast] Sets whether or not to issue the SDAP
([Disable] or [Enable]).
[SDAP Broadcast
Period] Sets the period (seconds) to issue the
SDAP.
Set from 05 to 30. (Default value: [15])
[Acceptable IP
Address] Sets the IP address to connect.
When the item is selected, you can set
[IP1] to [IP4].
 [Cancel]: Cancels the changed or
confirmed setting.
 [Confirm]: Saves the changed or
confirmed setting.
[Reset Protocol
Setting] Resets the protocol setting.
When the item is selected, the following
message appears.
[Are you sure ?]
 [OK]: To reset data, press the
ENTER (Ent) button.
 [Cancel]: To cancel, press the
MENU button.
Submenu Setting
[Parallel Remote] Selects whether or not to use the
parallel remote functions ([Off] or
[On]).
Submenu Setting