Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 46)

46
For details on the [Setting lock] function, see “[Setting
lock] Window” on page 55.
b Meter icons
These function identically to the meter icons in the status
viewer.
c Property tabs
These consist of the [Utility] tab and tabs for channels 1
and 2.
For details on the setting items in each tab, see “[Utility]
tab” on page 46 and “Channel tabs 1/2” on page 47.
d [Close] button
Closes the [Property] window.
[Utility] tab
Displays setting items that are equivalent to those in the
UTILITY menu of the receiver.
For details on each setting item, refer to the Operating
Instructions supplied with the receiver.
Receiver Type : In online mode, this displays the device
information acquired from the receiver and cannot be
changed. The device information can be changed in offline
mode.
Receiver Model : In online mode, this displays the
frequency band acquired from the receiver and cannot be
changed. The frequency band can be changed in offline
mode. Specify a frequency band that corresponds to the
actual device.
Receiver Name : Sets a name for the receiver.
Dante ID Mode: Displays the receiver’s Dante ID mode.
This function is not supported on the DWR-R01D,
DWR-R02D and DWR-R02DN.
Dante ID: Specifies the receiver’s Dante ID.
This function is not supported on the DWR-R01D,
DWR-R02D and DWR-R02DN.
View Advanced setting...: Displays the receiver’s
network settings. Click the button to display the following
screen.
This function is not supported on the DWR-R01D,
DWR-R02D and DWR-R02DN.
Network Mode: Specifies the receiver’s network
mode.
[Receiver IP]
IP Mode:
Specifies the receiver unit’s IP mode.
IP Address: Specifies the receiver unit’s IP address.
Subnetmask: Specifies the receiver unit’s subnet
mask.
[Dante Main IP]
IP Mode:
Specifies the IP mode for the receiver’s
Dante Main IP.
IP Address: Specifies the IP address for the receiver’s
Dante Main IP.
Subnetmask: Specifies the subnet mask for the
receiver’s Dante Main IP.
[Dante Sub IP]
IP Mode: Specifies the IP mode for the receiver’s
Dante Sub IP.
IP Address: Specifies the IP address for the receiver’s
Dante Sub IP.
Subnetmask: Specifies the subnet mask for the
receiver’s Dante Sub IP.
Band Block: Selects the frequency band to use (the largest
is 72 MHz).
This function is not supported by the DWR-R01D and
DWR-R02D.
Note
Note
Note
Note