Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 59)

59
[Other] tab
This tab allows you to enable or disable audio output
control. It is disabled under factory default settings.
When the checkbox is selected, you can enable or disable
audio output by clicking the audio output control /
indicators for each receiver channel in the status viewer.
• Checkbox cleared
• Checkbox selected
[Other settings] Window
The [Other settings] window allows you to configure the
peak level hold condition of the AF level meter that
appears in the status viewer and switch the unit display for
the RF level.
[AF peak hold setting]
Configures hold settings for the peak levels of the AF level
meters that appear in the status viewer.
2sec : Holds for 2 second.
HOLD : Hold is maintained until it is released.
[The unit of RF level]
Selects the units (dBuVemf or dBm) for the RF level that
appears in the [RF Chart Grapher] tab and the [Channel
Plan Adviser] window.
Releasing the hold status
Peak levels that are being held can be released in the main
page of Wireless Studio.
Clicking [Clear AF Peak hold] in the status viewer releases
the hold status of the peak levels for all the receiver
channels displayed.
[Network settings] Window
This windows displays the network settings of the
receivers, battery chargers, and RMU-01 units on the
network.
a Receivers list
Displays the values of the receiver’s network settings.
Type : Displays the receiver’s type.
Name : Displays the value of the receiver’s RECEIVER
NAME setting.
Network mode : Displays the value of the receiver’s
NETWORK MODE setting.
IP Mode : Displays the value of the receiver’s IP MODE
setting.
IP Address : Displays the value of the receiver’s
ADDRESS setting.
Subnetmask : Displays the value of the receiver’s
SUBNETMASK setting.
Dante Main IP Mode : Displays the value of the receiver’s
DANTE MAIN IP MODE setting.
Dante Main IP Address : Displays the value of the
receiver’s DANTE MAIN IP ADDRESS setting.
Dante Main Subnetmask : Displays the value of the
receiver’s DANTE MAIN SUBNETMASK setting.
Dante Sub IP Mode : Displays the value of the receiver’s
DANTE SUB IP MODE setting.
Dante Sub IP Address : Displays the value of the
receiver’s DANTE SUB IP ADDRESS setting.
Dante Sub Subnetmask : Displays the value of the
receiver’s DANTE SUB SUBNETMASK setting.
“NO FUNCTION” is displayed for the following items for
receivers other than the DWR-R03D.
• Network Mode
• IP Mode
• Subnet Mask
Note
1
2