Nikon 20x120 IV Telescopic Binoculars with Fork Mount - Manual (Page 13)

13
Jp
En
Adjusting the orientation and tilting
angle of the body
● Changing the orientation: You can rotate
the body horizontally in 360 degrees.
1. Rotate the rotation clamp screw on the
fork mount counter-clockwise to loosen it
( G ).
2. Adjust the orientation, and rotate the
rotation clamp screw clockwise to tighten
it.
G
Rotation
clamp screw
● Changing the tilting angle: You can adjust
the angle of the body from 70 degrees
above to 30 degrees below.
1. Hold the eyepiece lens or prism box with
your left hand to firmly support the body.
2. Rotate the tilting clamp screw on the
body counter-clockwise with your right
hand to loosen it ( H ).
• When it is loosened, the body will tilt to
the objective lens side. Firmly support
the body with your left hand so that the
body is not subjected to physical impact.
3. Adjust the angle, and rotate the tilting
clamp screw clockwise to tighten it.
H
Tilting clamp screw
After using the binocular telescope, make sure to tighten the screws
and check that the body and fork mount are secured.