Upconversion, Upconvert off – Teac VRDS-701T 70th Anniversary CD Transport (Black) User Manual
Page 25
EN
25
6
When you are done changing settings, press
the MENU button to show the input source sta-
tus again.
o
If you do not do anything for about seven seconds, the dis-
play will return to showing the input source status.
Upconversion
Use this to set use of the upconversion circuit when receiving PCM
signals.
o
See page 15 for the relationships between input sampling fre-
quencies and sampling frequencies after upconversion.
MENU
UPCONVERT
OFF
OFF
The input signal is sent as is to the D/A converter without being
upconverted.
2× Fs
If the input audio signal is less than 2× a standard sampling fre-
quency, it is upconverted 2× and then sent to the D/A converter.
4× Fs
If the input audio signal is less than 4× a standard sampling fre-
quency, it is upconverted 4× and then sent to the D/A converter.
8× Fs
If the input audio signal is less than 8× a standard sampling fre-
quency, it is upconverted 8× and then sent to the D/A converter.
NOTE
This can be set directly with the remote control UPCONVERT button.