Epson 61p - Manual (Page 16)

16 Setting Up the Projector
Connecting to a Computer
You can connect the PowerLite projector to any computer that has a
standard VGA or BNC monitor port, including PC notebook and
laptop computers, Macintosh PowerBooks and iBooks, and hand-held
devices. You can connect two computers at the same time.
Follow the instructions in this section to:
■ Connect the projector to your computer with the VGA cable
included with the projector.
■ Connect the projector to your computer with a
commercially-available VGA–5BNC cable.
After connecting the projector to your computer, you may also
want to:
■ Connect the USB cable that came with your projector so that you
can use the remote control as a wireless mouse; see page 19
■ Connect a monitor to the projector so you can view your
presentation close-up as well as on-screen (not necessary if you’re
using a laptop); see page 20
■ Connect a commercially-available computer audio cable to play
computer audio; see page 21
Connecting with the VGA Cable
Follow these instructions to connect to your computer with the VGA
cable that came with your projector. Before you start, make sure your
computer and the projector are turned off.
1. If you are connecting the projector to a desktop computer,
disconnect the monitor cable from your computer.
2. Locate the VGA computer cable that
came with the projector.
note
If you have an iBook with an
RCA video-out port, follow
the instructions for
connecting to a video device
on page 23.
VGA computer cable