Epson 61p - Manual (Page 38)

38 Projecting
Adjusting the Image Shape
The projector automatically corrects images that are distorted when
the projector is tilted up or down (up to a 15° tilt). The Keystone
window appears on the screen while the projector makes the
correction. If the projected image still isn’t rectangular or has a
“keystone” shape, do one or more of the following:
■ If your image looks like or , you’ve placed the
projector off to one side of the screen, at an angle. Move it directly
in front of the center of the screen, facing the screen squarely.
■ If your image looks like or , the Auto Keystone feature
may have been disabled or you may need to manually adjust the
keystone correction value. (Auto Keystone is not available when
you’re using ceiling or rear projection.) Follow the directions
below:
■ To turn on Auto Keystone, press the Menu button on the
remote control. Use the pointer button on the remote
control (or the arrow buttons on the projector) to select the
Setting menu, then press Enter . If Auto Keystone is OFF ,
use the pointer button to highlight this option and press
Enter . Select ON in the Auto Keystone window that appears
and press Enter to save your changes. Exit the menu by
pressing the Menu button.
■ To manually adjust the keystone correction value, press the
or buttons on the projector to correct the shape of
the image. After correction, your image will be slightly
smaller.
Enter button Menu buttton
Pointer button
note
You can also use the buttons
on the projector to access the
menu system:
Menu button ESC button
Enter button Arrow buttons