Epson 61p - Manual (Page 60)

60 Fine-tuning the Projector
■ Projection
Front: Projector is in front of the screen.
Front/Ceiling: Projector is in front of the screen, mounted
upside-down from the ceiling.
Rear: Projector is behind the screen.
Rear/Ceiling: Projector is behind the screen, mounted
upside-down from the ceiling.
■ Operation
Direct Power: When this feature is enabled, projection starts
as soon as you plug in the power cord. You don’t have to
press the P
Power button.
Sleep Mode: When this feature is enabled, the projector
lamp automatically turns off when the projector has not
received any input signals for 30 minutes. This conserves
electricity, cools the projector, and extends the life of the
lamp. To resume projecting, press the P
Power button.
■ Standby Mode
Set to Network ON to monitor your projector over a
network and perform other network functions when the
projector is in standby mode.
■ COM Port
Turn on USB only if you’re controlling the projector from a
computer with the EMP Link 21L software. This software
can be downloaded from the Epson website at
support.epson.com. (You must turn the projector off and
then on again to use the new setting.)
■ Language
Select the language to be used for the projector menus.
4. When you’re finished, press Esc or Menu .
note
When Direct Power
is turned on, press the
P
Power button to turn
the projector off, wait until
the P power light turns a
steady orange, then unplug
the power cord.