Epson 61p - Manual (Page 41)

Projecting 41
Adjusting the Volume
You can use the buttons on the remote control or projector to increase
or decrease the volume for both the projector’s built-in speaker and
external speakers connected to the projector. Press the
button to
increase the volume, or the button to decrease it. A volume gauge
appears on the screen while the volume is being adjusted.
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. If you’re using a computer, shut it down first; otherwise you may
not be able to see your computer’s display to shut it down
properly.
2. To turn off the projector, press the P Power button on the
projector or remote control.
You see this confirmation message:
(If you don’t want to turn it off, press
any other button or wait a few
seconds until it disappears.)
note
You can also adjust the
volume using the projector’s
Setting menu. See page 57
for details.
You must adjust the volume
separately for each input
source.
Volume controls
note
When the projector has not
received any input signals for
30 minutes, it automatically
turns off the projector lamp
and enters “sleep mode.” This
conserves electricity, cools the
projector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the P
Power button. You
can turn sleep mode on or off
through the Extended menu.
See page 59.