Epson 61p - Manual (Page 56)

56 Fine-tuning the Projector
3. Press Enter . Then use the pointer button (or up and down
arrow buttons) and the Enter button to select any of the
following options:
■ Auto Setup (computer images)
Leave this setting ON to automatically optimize the computer
image. Turn it off if you want to save adjustments you have
made to the video settings.
■ Tracking (computer images)
Removes unwanted vertical lines from a computer image by
matching the projector’s internal clock to various computer
signals. See page 88 for more information about adjusting the
tracking.
■ Sync (computer images)
Corrects fuzziness or screen flicker by synchronizing the
projector with the tracking signal sent from the computer.
See page 88 for more information about adjusting the sync
setting.
■ Position
Use the pointer button or arrow buttons to move the
image on the screen left, right, up, or down.
■ Computer 1 Input
Selects the signal from equipment connected to the
Computer1/Component Video1 port. If your image colors
look wrong, try changing this setting from Auto to one of the
following: RGB for computer or RGB video sources, or
Component Video for component video sources.
■ Computer 2 Input
Selects the signal from equipment connected to the
Computer2/Component Video2 port. If your image colors
look wrong, try changing this setting from Auto to one of the
following: RGB for computer or RGB video sources, or
Component Video for component video sources.
note
If you have repositioned the
image but then change your
mind, you can press the
Auto button on the remote
control to restore the default
settings.