Midi channel parameters, User channel, Mackie control / hui – Arturia BeatStep Pro MIDI/Analog Controller and Sequencer Kit with CV/Gate Cables (Black) User Manual
Page 123: Midi channel, Parameters [p.118
10.9.3. MIDI Channel parameters
10.9.3.1. User Channel
Use the pull-down menus to select the User MIDI Channel for BeatStep Pro. This is the
same parameter as the Control Mode MIDI Channel that you can set from the front panel.
Changing the User Channel is a quick way to reassign many controls at once.
There are also separate Send and Receive MIDI Channels for each sequencer:
• Seq1 Send MIDI Channel (Range: 1-16)
• Seq1 Rcv MIDI Channel (Range: 1-16, User, All)
• Seq2 Send MIDI Channel (Range: 1-16)
• Seq1 Rcv MIDI Channel (Range: 1-16, User, All)
• Drum Send MIDI Channel (Range: 1-16)
• Drum Rcv MIDI Channel (Range: 1-16, User, All)
Each of the sequencers can be set to receive on the User channel (defined above). They can
also be set to a value of All, which is also known as "Omni mode". This means that particular
sequencer will receive data from any one of the 16 MIDI channels (or all of them).
10.9.4. Mackie Control / HUI
This parameter toggles the encoders between their MIDI CC assignments in Control Mode
and their MCU/HUI protocol assignments.
For a detailed list of these assignments, see the list in the
section of the
chapter.
Arturia - User Manual BeatStep Pro - MIDI Control Center
118