Projects, Loading a project, Projects [p.49 – Arturia BeatStep Pro MIDI/Analog Controller and Sequencer Kit with CV/Gate Cables (Black) User Manual
Page 54: P.49, Project [p.49
5. PROJECTS
There are many independent features for each sequencer. But a Project is where you will
find parameters that affect all three sequencers at the same time.
The internal memory of the BeatStep Pro holds a total of 16 Projects. You could think of a
Project as a single song (although it could be an entire performance). Each one contains:
• 16 patterns for each of the three sequencers (SEQ1, SEQ2 and DRUM), including
all of the Swing, Randomness and Probability settings for each pattern
• A Control Mode preset (i.e., a controller map), with independent settings for each
assignable control
• 16
(these are only active when Scene Mode has been enabled using
the
• Project-level settings for Tempo, Swing, Randomness and Probability.
See the
section of the
chapter for information about
other parameters that affect the way Projects respond when you switch from one Project to
the next.
5.1. Loading a Project
To load a Project, hold the PROJECT button and press the Step button that corresponds to
the number of the Project you want to load. Be sure you have saved your current Project
somewhere before you do this!
Projects can also be loading during performance while the sequences are running.
♪
: The
has a parameter that allows you to specify whether the new Project
should be loaded instantly or wait until after the Drum sequencer reaches the end of its current pattern.
See the
section to learn about this feature.
49
Arturia - User Manual BeatStep Pro - Projects