Explore Scientific SmMultichannel Weather Station with Wireless Sensor - Manual (Page 8)

8
1 2
3
4
5
WIRELESS THERMO-HYGRO SENSOR
1. LED indicator
2. Wall mounting holder
3. Channel slide switch
4. [ RESET ] key
5. Battery compartment
INSTALLATION AND SETUP
INSTALL WIRELESS THERMO-HYGRO SENSOR
NOTE:
-If you need to re-assign the sensor channel, slide the channel slide switch
to the new channel position and press [ RESET ] key on the sensor for the
new channel number to be effective.
- Avoid placing the sensors in direct sunlight, rain or snow.
1. Remove the battery door of the sensor.
2. Use the channel slide switch to set the channel number for the
sensor (e.g. Channel 1)
3. Insert 2 x AA size batteries into the battery compartment according
to the polarity marked on the battery compartment, and close the
battery door.
4. The sensor is in synchronization mode, and can be registered to the
console within the next few minutes. The transmission status LED
will begin to flash every 1 minute.