Denon AVR-S570BT 5.2-Channel A/V Receiver - Manual (Page 81)

o HDMI Pass Through
Selects how this unit will transmit HDMI signals to the HDMI output in
standby power mode.
On
(Default):
Transmits the selected HDMI input
through this unit’s HDMI output when this
unit is in standby power mode.
Off:
No HDMI signals are transmitted through
this unit’s HDMI output in standby power
mode.
o Pass Through Source
Sets the HDMI connector that inputs HDMI signals when in standby.
Last:
The most recently used input source will
go into standby mode.
CBL/SAT / Media Player /
Blu-ray / Game
(Default: CBL/SAT):
Pass through the selected input source.
0
“Pass Through Source” can be set when “HDMI Pass Through” is set to “On”
or “HDMI Control” is set to “On”. (“HDMI Pass Through” ( v p. 81), “HDMI
Control” ( v p. 81))
o HDMI Control
You can link operations with devices connected to HDMI and
compatible with HDMI Control.
On: Use HDMI Control function.
Off
(Default):
Do not use HDMI Control function.
0
Please consult the operating instructions for each connected device to check
the settings.
0
When “HDMI Control” is set to “On”, this unit’s power status can be linked to
that of the TV and this unit’s volume can be controlled using the TV remote
control.
0 Refer to “HDMI Control function” for more information about the HDMI Control
function. ( v p. 64)
NOTE
0
If the “HDMI Control” settings have been changed, always reset the power to
connected devices after the change.
Contents Connections Playback Settings Tips Appendix
81
Front panel Display Rear panel Remote Index