Emulex NQTR0V-NATM - Manual (Page 146)

Lan Manager 7-3
Before Installation
We recommend writing down the following parameters from the Setup
Section in Chapter 2. Refer to them during the installation procedure.
Default Server Name: ____ ____ ____ ____ ____ ____ ____ ____ ____
Default Printer Name: ___ ___ ___ ___ ___ ___ ___ ___ ___ _ ___
IP Address: ___ ___ ___-___ ___ ___ -___ ___ ___-___ ___ ___
TCP port _______ (parallel port) TCP port _______ (parallel port)
TCP port _______ (serial port) TCP port _______ (serial port)
Telnet port number _______ RCF port number _______
Have the TES & LAN Manager diskette or the CD-ROM ready for
installation.
Verify Configuration
Check the system configuration before installing Print Manager for TCP/IP
printing.
TCP/IP Stack
Every server and client must have the TCP/IP stack loaded before the server
or client can send a print job to the printer server.
1) Login to the LAN Manager server as admin.
2) Go to the LANMAN directory.
3) Run S ETUP .
4) Pull down the C ONFIGURATION menu.
5) Select N ETWORK D RIVERS .
A TCP/IP entry should be listed. If this entry is not present, refer to
LAN Manager documentation for information on installing and enabling
the TCP/IP protocol stack. When finished, exit
SETUP .