Emulex NQTR0V-NATM - Manual (Page 137)

6-2 Chapter 6
Logging into the Printer Server
You can login to the printer server remotely from a UNIX workstation or
locally from a console terminal.
1) Login to a UNIX TCP/IP workstation.
The prompt may appear different than the one shown below.
2) Connect to the printer server:
>
# telnet ip_address 2048
ip_address The printer server IP address in decimal dot
notation. For example: 123.234.345.456.
2048 The printer server RCF port
3) Enter the password:
>
# access
where access is the default printer server remote login password.
NOTE: The password does not appear when typed.
4) Verify banner.
When the connection is made, the printer server login banner is
displayed.
5) At Enter Username or Help>, enter any two characters.
6) At Server>, enter su:
>
Server> su
This gives you supervisor status.
7) At Password>, enter system:
>
Password> system
where system is the default privileged password which does not echo
back.
8) At the Server>> prompt, view or change current parameters.
Refer to the list of commands in the Command Reference Guide.