Emulex NQTR0V-NATM - Manual (Page 60)

2-40 Chapter 2
NOTE: We suggest you use the default printer server name
when installing the printer server for the first time.
To determine the default printer name, enter the Emulex default printer server
name combined with the Emulex printer server port number. Port numbering
on the NETQue Token Ring is as follows:
• #1 - Parallel port
• #2 - Serial port
For example, NQT01A06A_2 is the NETQue Token Ring serial port.
Default Printer Name: NQT____ ____ ____ ____ ____ ____ _ ____
Switch Settings
A four position switch is located on the network side of the printer server.
The functions of each are shown below. UP indicates a switch is ON and
DOWN shows the switch is OFF.
Position 1 Reset to Factory Defaults
ON = Reset to Factory Default
OFF = Use for Normal Operation
Position 2 Token Ring Speed
ON = 4 Mbits/sec
OFF = 16 Mbits/sec
Position 3 Parallel Port Type
ON = Bi-directional
OFF = Centronics
Position 4 Reserved for Future Use
Figure 2-22: Switch Settings
O
N