Elo TouchSystems 1525L - Manual (Page 100)

SECTION 2. PROPERTIES
This section lists the properties that are used in the MagTek Drivers. Properties can be
interrogated by issuing a
get
command and modified with a
set
command. Refer to Section 3.
Commands for complete description and examples of all commands.
The
c_xxx
properties are set by the driver and reflect the device’s capabilities. However, the
c_xxx
properties do not indicate the configuration of the device. For example, a device may be
capable of reading all three magnetic tracks but be configured to only read two tracks or a MICR
reader, while often configured with a magnetic stripe reader, may not have an MSR installed.
Unless otherwise noted,
1
means the capability is available,
0
or null (i.e., the value is not
present) means that the capability is not available.
In this table, the Access information indicates whether the property can be modified (Read/Write
–R/W) or merely accessed (Read Only–R).
Property Access Description
account_no R/W Cardholder account number, including check digit. It is set by the
application to be used in PIN encryption commands (IntelliPIN).
amount R/W Transaction amount in cents, without punctuation (IntelliPIN).
applied_fmt R Indicates which format template was used to parse the magnetics
data. If no template or rule is applied, this property returns a null.
c_card_stat R
1
indicates that the driver supports retrieval of card sensor status
(e.g., PPINSERT)
c_cardwpin R
1
if the device supports reading of a card and a PIN in response to
a single command (e.g., IntelliPIN).
c_check R
1
if the device can read checks (e.g., MICR devices).
c_events R
1
indicates that the driver supports unsolicited event notification
(e.g., PPINSERT).
c_keypress R
1
if the device supports retrieval of a key press (e.g., IntelliPIN).
c_keystring R
1
if the device supports retrieval of a sequence of key presses (e.g.,
IntelliPIN).
c_magnetic R
1
if the device can read magnetic cards.
c_mechanics R This value indicates how the card reader’s mechanism operates:
0
– manually operated device or no card reader
1
– device is mechanized and supports “eject”
2
– device is mechanized and supports “eject” and “confiscate”
c_pin R
1
if the device supports reading of PINs (e.g., IntelliPIN).
c_smart R
1
if the device supports smart cards.
c_tracks R A three-character string, representing the tracks supported by the
device. The left-most position indicates track 1. Thus
110
indicates that the device can access tracks 1 and 2 but not track 3.
See
trk_enable
to determine which tracks are enabled.