Elo TouchSystems 1525L - Manual (Page 115)

MagTek Device Drivers for Windows
112
reset
Function Reset the device.
Syntax /reset
Errors none
Remarks Clear any pending operations and reset the device to initial state (for mechanized
card devices this command will also eject the card). This does not affect any of the
properties.
Example To return a device to its initial state:
Command /reset <LF>
Response none
set
Function Set a property.
Syntax
/set
prop val
prop is one of the valid properties (R/W) shown in Section 2. Properties
val represents the value of that property.
Errors none
Remarks This command is used to define each of the properties that are required prior to
sending a command.
Example To load the key serial number in the IntelliPIN:
Command /set enc_key_sn 0123456789012345 <LF>
Response none
ver
Function Read driver version.
Syntax /ver
Errors none
Remarks The response to this command is sent in the following format:
/ver
num text
num is the driver’s part number
text is a free format version string. It may contain a tagged-format data enclosed
in parentheses, as shown in this example
This is not the version of the device.
Example To determine the version of the currently active driver:
Command /ver <LF>
Response
/ver 30037395 Mag-Tek Device Driver
(Version=1.04 Model=IntelliPIN) <LF>