Elo TouchSystems 1525L - Manual (Page 101)

MagTek Device Drivers for Windows
98
Property Access Description
c_write R
1
if the device can encode a magnetic card in either LoCo or HiCo;
2
if the device can encode a magnetic card in only the setting
indicated in
wr_coer
c_wr_secure R
0
if the device does not support secure mode;
1
if the device can switch between secure and non-secure mode
(see
wr_secure
);
2
if the device only operates in the secure mode.
capitalize R/W Set this to
0
to prevent the driver from capitalizing the data for the
read
and
write
commands. The default value for this property is
1
(enable capitalization).
card_stat R Current card sensor status:
0
= not blocked,
1
= blocked (PPINSERT).
chk_account R Check account number from check (MICR).
chk_amount R Check amount from check (MICR).
chk_bankid R Bank ID number from the transit field (MICR).
chk_data R Output data string as received from MICR reader (MICR).
chk_format R/W Indicates the format of the check data. Set to
6500
by default. If
this property is modified by the application, the
chk_xx
properties
(except
chk_data
and
chk_status
) will be set to null. (MICR)
chk_mod10 R Mod10 check digit from the transit field (MICR).
chk_number
R Check number (MICR).
chk_routing R Routing number from the transit field (MICR).
chk_status R 2-digit status code from the check just read (MICR).
chk_transit R Transit number from check (MICR).
cmd_pending R Command pending–indicates which command, if any, is pending.
If none is pending, the second argument will be null:
/get cmd_pending <LF>
dblpinentry R/W Set to
1
to enable double PIN entry such as when requesting a new
PIN; set to
0
when verifying a customer’s PIN (IntelliPIN).
dev_status R Device status.
0
means device is connected and operational. Any
other value indicates a device-specific error. If the device fails to
respond, a null value is reported:
/get dev_status <LF>
dev_version R Device version string. This value is read directly from the device,
if the device supports a version string.
<CR>
characters in the
string read from the device will be replaced with
/
. This property
will be useful in reporting operational problems to MagTek.
enable_cmc7 R/W Set this property to
1
to enable CMC-7 characters decoding,
0
to
disable it. This is used for international checks; see MICR manual
for more information. (MICR)