Edimax Technology Edimax user guide Router - Manual (Page 22)

Page 18
• Set
your Default Gateway to the IP Address of The Load Balancer.
• Ensure
your DNS (Name server) settings are correct.
To act as a DHCP Client (recommended)
The procedure below may vary according to your version of Linux and X -windows shell.
1. Start your X Windows client.
2. Select Control Panel - Network
3. Select the "Interface" entry for your Network card. Normally, this will be called "eth0".
4. Click the Edit button, set the "protocol" to "DHCP", and save this data.
5. To apply your changes
Use the "Deactivate" and "Activate" buttons, if available.
OR, restart your system.