Edimax Technology Edimax user guide Router - Manual (Page 68)

Page 64
Data – System Status
WAN
Information
• Connection Status – Current status – either "Connected" or "Not connected".
• Connection Type – The type of connection used – DHCP, Fixed IP, PPPoE,
or PPTP.
• "Force Renew" button– Only available if using a dynamic IP address
(DHCP). Clicking this button will perform a DHCP "Renew" transaction with
the ISP's DHCP server. This will extend the period for which the current WAN
IP address is allocated to you.
• IP Address – The IP address of The Load Balancer, as seen from the
Internet. This IP Address is allocated by the ISP (Internet Service Provider)
• Subnet Mask – The Network Mask (Subnet Mask) for the IP Address above.
• Domain Name IP Address – The address of the current DNS (Domain Name
Server.
• MAC Address – The MAC (physical) address of The Load Balancer, as seen
from the Internet.
LAN
Information
• IP Address – The LAN IP Address of The Load Balancer.
• Subnet Mask – The Network Mask (Subnet Mask) for the IP Address above.
• MAC Address – The MAC (physical) address of The Load Balancer, as seen
from the local LAN.
• DHCP Server – The status of the DHCP Server function - either "Enabled" or
"Disabled".
Device
Information
• Firmware Version – Version of the Firmware currently installed.
• NAT – Status of the NAT feature – either “Enable” or “Disable”.
• Load Balance – Status of the Load Balance feature – either “Enable” or
“Disable”.
• Virtual Server – Status of the Virtual Server feature – either "Enabled" or
"Disabled".
• Special Applications – Status of the Special Applications feature – either
"Enabled" or "Disabled".
• DMZ – Status of the DMZ feature – either "Enabled" or "Disabled".
• Block URL – Status of the Block URL feature – either “Enable” or “Disable”.
• Hardware ID – The manufacturers ID for this particular device.
Device
Statistics
• System UpTime – The time since the system of a device was last
reinitialized.
• CPU Usage – The current usage percentage of CPU.
• Memory Usage – The current usage percentage of Memory (Heap & Queue).