Edimax Technology IC-1000 - Manual (Page 23)

23
Setting Wizard
Internet Camera Name The default camera name is “IPCamera_MJPEG”. It is
recommended to enter a meaningful name for the camera.
IP Address The wizard will auto setup an available IP Address to the camera.
For example: if the IP address of the network is 192.168.2.x, the
wizard will search an unused IP Address from 192.168.2.250 to
192.168.2.0 and assign the camera an available IP Address.
You are allowed to enter another IP Address to change the
setting.
Subnet Mask The wizard will auto search the Subnet Mask setting of the
network and set the camera in the same Subnet Mask.
You can enter another Subnet Mask to change the setting.
Gateway The wizard will auto search the Gateway setting of the network
and set the camera to use the same Gateway.
You can enter another Gateway to change the setting.
Video Port It defines the video stream port. The default value is “4321”.
Cancel Click “Cancel” to stop wizard setting.
Finish Click “Finish” to complete the camera setting.
When you finish the camera setting, you can click “Ok” to run the “Camera Viewer”
immediately or click “Cancel” to run the “Camera Viewer” later.