Epson 8000i - Manual (Page 65)

Connecting to a Video Source 55
4. Connect the RCA audio cable to the Audio ports of the projector:
insert the white plug into the L port and the red plug into the R
port. Connect the plug at the other end of the RCA audio cable to
the audio output ports of the video source.
5. For S-Video, insert one end of an S-Video cable into the
projector’s S-Video connector. Insert the other end into the
S-video-out port of your video source.
6. For component video, insert three ends of a BNC cable into the
projector’s R/R-Y, G/Y, and B/B-Y ports. Insert the opposite ends
of the cable into the Y/Video, C/R-Y, and B-Y ports on your
component video source. (Don’t insert any of the cable ends into
the HD/Sync and VD ports.)
Note: Use a standard BNC cable, which you can purchase from any
computer store. The Computer 2/BNC video cable supplied by
EPSON as an optional accessory does not work with component video.
S-Video cable S-Video connector
80009000.book Page 55 Monday, November 1, 1999 9:35 AM