Epson 8000i User Manual
Page 85
Controlling the Projector
75
Note: To be able to use the remote control as a wireless mouse, make sure
you’ve connected the mouse cable to the projector and your computer. (See
Chapter 1 for instructions.)
The five Special Effects buttons are preprogrammed with the
following options:
1 Change the mouse cursor to a stamp
2 Draw a box
3 Use a marker pen
4 Draw a freehand line
5 Clear the screen
For information on changing these special effects, see page 107.
The projector may not respond to remote control commands in these
conditions:
❐
The R/C (remote control) on/off switch is in the OFF position
❐
Batteries are weak
❐
Ambient light is too bright
❐
A certain type of fluorescent light is present
❐
A strong light source (such as direct sunlight) shines into the
infrared receiver
❐
Other equipment emitting infrared energy is present (such as a
radiant room heater)
Correct these conditions to use the remote control or control the
projector from a computer.
80009000.book Page 75 Monday, November 1, 1999 9:35 AM