Encore electronic ENDSL-A2+WIG2 - Manual (Page 58)

7.3.7 IP Address Mapping
The IP Address Mapping is for those VCs that with multiple IPs. The IP Address Mapping
rule is per-VC based. (only for Multiple IPs’ VCs).
Rule Index: The Virtual server rule index for this VC. You can specify up to 10 rules. All the
VCs with single IP will use the same Virtual Server rules.
Rule Type: There are 4 types of One-to-One , Many-to-One, Many-to-Many Overload , and
Many-to Many No-Overload .
Local Start & End IP: Enter the local IP address you plan to map to. Local Start IP is the starting
local IP address & Local End IP is the ending local IP address. If the rule is for all local IPs, then
the Start IP is 0.0.0.0 and the End IP is 255.255.255.255.
Public Start & End IP: Enter the Public IP Address you want to do NAT. Public Start IP is the
starting Public IP Address and Public End IP is the ending Public IP Address. If you have a
Dynamic IP, enter 0.0.0.0 as the Public Start IP.
57
When you are done making changes, click on SAVE to save your changes, DELETE to delete
the rule with the parameters you set, BACK to return to the previous screen or CANCEL to exit
without saving.