Encore electronic ENDSL-A2+WIG2 - Manual (Page 61)

optimization.
(1) Port-Based VLAN: each physical switch port is configured with an access list specifying
membership in a set of VLANs.
(2) ATM VLAN-using LAN Emulation(LANE) protocol to map Ethernet packets into ATM cells
and deliver then to their destination by converting an Ethernet MAC address into an ATM
address.
The key for the IEEE 802.1Q to perform the above functions is in its tags. 802.1Q-compliant
switch ports can be configure to transmit tagged or untagged frames. A tag field containing VLAN
(and/or 802.1p priority) information can be inserted into an Ethernet frame. If a port has an
802.1Q-compliant device attached (such as another switch), these tagged frames can carry
VLAN membership information between switches, thus letting a VLAN span multiple switches.
However, it is important to ensure ports with non-802.1Q-compliant devices attached are
configured to transmit untagged frames. Many NICs for PCs and printers are not
802.1Q-compliant. If they received a tagged frame, they will not understand the VLAN tab and
will drop the frame. Also, the maximum legal Ethernet frame size for tagged frames was
increased in 802.1Q (and its companion, 802.3ac) from 1518 to 1522 bytes. This could cause
network interface cards and older switches to drop tagged frames as “oversized”
Î Assign VLAN PVID for each interface: You can assign ATM VC, Ethernet (LAN) port, and
Wireless LAN port’s PVID in this section.
Î Define VLAN Group: Based on each VLAN group, you can configure each group’s VLAN
setting. You can configure up to 8 VLAN settings.
60