Epson 10000XL User Manual
Page 73
Solving Problems
73
■
Try applying the
Unsharp Mask
Filter
■
Make sure the document table
glass is clean.
■
Make sure the scanner is on a flat,
stable surface, and your document
didn’t shift during scanning.
The edges of the document aren’t
scanned properly.
■
Don’t place your document right
up against the edges of the
document table. Move the
document about 1/16 of an inch
away from the edges.
■
If colors are patchy or distorted at
the edges of the image, the
document may be too thick, or
there may be outside light
interfering with the scan. If you are
scanning without the cover, place
paper over the edges of the
document to block outside light.
Your image scans at an angle.
■
Check the position of your
document. Carefully align it with
the edges of the document table.
■
Try using the Thumbnail preview
screen to scan your image (see
page 15). The Thumbnail preview
automatically corrects the angle of
the image if it’s tilted.
Straight lines in the image come out
jagged.
■
Make sure the document is aligned
with the edges of the document
table.
■
Try scanning your image at a
higher resolution (dpi).
10000XL.book Page 73 Friday, June 4, 2004 1:57 PM