Hearth and Home Technologies Everest - Manual (Page 8)

Heat & Glo • Everest • 750-900 Rev. o • 10/08 8
2
Getting Started
Introducing the Heat & Glo Gas Fireplaces
Heat & Glo direct vent gas fi replaces are designed to op-
erate with all combustion air siphoned from outside of the
building and all exhaust gases expelled to the outside.
The information contained in this Installers Guide, unless
noted otherwise, applies to all models and gas control
systems. Gas fi replace diagrams, including the dimensions,
are shown in this section.
Pre-install Preparation
This gas fi replace and its components are tested and safe
when installed in accordance with this Installers Guide.
Report to your dealer any parts damaged in shipment,
particularly the condition of the glass. Do not install any
unit with damaged, incomplete, or substitute parts.
The vent system components and trim doors are shipped
in separate packages. The gas logs may be packaged
separately and must be fi eld installed.
Read all of the instructions before starting the
installation. Follow these instructions carefully during
the installation to ensure maximum safety and benefi t.
Failure to follow these instructions will void the owner’s
warranty and may present a fi re hazard.
When planning a fi replace installation, it’s necessary to
determine:
• Where the unit is to be installed.
• The vent system confi guration to be used.
• Gas supply piping.
• Electrical wiring.
• Framing and fi nishing details.
• Whether optional accessories devices such as a fan, wall
switch, or remote control are desired.
If the fi replace is to be installed on carpeting or tile, or on
any combustible material other than wood fl ooring, the
fi replace should be installed on a metal or wood panel that
extends the full width and depth of the fi replace.
Warranty
The Heat & Glo Warranty will be voided by, and Heat & Glo
disclaims any responsibility for, the following actions:
• Installation of any damaged fi replace or vent system
component.
• Modifi cation of the fi replace or direct vent system.
• Installation other than as instructed by Heat & Glo.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not manu-
factured and approved by Heat & Glo, not withstanding
any independent testing laboratory or other party ap-
proval of such component part or accessory.
ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE
HAZARD.